Faceswap Forum

I think I'm starting to get the hang of the manual tool. One thing I'm not sure is intentional or a bug is how the mask gets recalculated when changing things.

I noticed this when adding alignments for frames that were missing them, but had clear faces.

Basically, I use the bounding box tool to create a bounding box, and get it to look like it's correctly identifying the face.

Then I move to look at the mask view, and the mask that's generated seems to be based on the old/original location of the bounding box (where I first clicked to create it, before sizing/moving/tuning it).

To fix it, I have to go to the other box editor (location box? the green one), and make a change (e.g. slide it by a few pixels), at which point, if I go back into the mask view, it's correctly regenerated based on the landmarks.

Is this a bug? I think it might be, since redetecting landmarks by moving the bounding box should probably also regenerate the mask.

It should. I will need to check. I will look when I have a chance (may not be for a while).

Thanks for the heads up. I'm tagging your post with bug to remind me to revisit.

Sweet thanks!

It's easy to work around, but the extra clicks add up if doing many frames.

Does this issue still occur for you? I have attempted to recreate but it all seems to work fine for me.

Yes, but I have not yet done a faceswap update on my box since the first time installing. I'll re-install to get the latest and get back to you... hopefully I can just run the install script and it'll do a graceful update.

OH! Looks like you can update through the UI. I just did, and it looks good now, mask is propagating with box change. Thanks for the fix!