Halo effect around face on side B causes side A to have halo effect and not cover full face.
The mask and alignment for both sides are almost perfect. When using the manual tool to look at the frames, the mask and alignments cover up the face correctly. But as I’m training, side b doesn’t cover the full face on side A causes a halo effect when converting. I tried changing a bunch of the convert settings and it doesn’t work. e.g. Box blend, Mask blend, color, etc. Only changing “erosion” has very little effect but it takes too much of the face away and doesn’t completely overlay the face you are trying to replace. I have tried with multiple sources and it does the same thing. I don’t notice a difference when training longer. Mask type and color adjustment doesn’t make any difference either. The training set for both sides is 1024x1024. It wouldn't be too bad if I could blend the halo effect into the face, but nothing is doing that. Is there anything I’m missing or need to change?
I am using Phaze-A. RTX3060