Page 1 of 1

Full Face not being replaced

Posted: Thu Mar 12, 2020 3:19 pm
by Brabrah

So I'm struggling a little bit in conversion. My A face set is a person with a beard and the B face set is a person without. I'm training with 80% coverage right now. I'm pausing and running convert throughout the model to check progress, and it looks like the face isn't being fully replaced, leaving the beard below the chin of the B face after conversion, giving B a sort of Amish look. Do I need to increase coverage to 100%? is there a way to scale up B face to make it cover the beard better?


Re: Full Face not being replaced

Posted: Thu Mar 12, 2020 3:36 pm
by bryanlyon

See viewtopic.php?f=6&t=74 especially the section titled "Avoid beards that go outside the face area".


Re: Full Face not being replaced

Posted: Thu Mar 12, 2020 5:23 pm
by Brabrah

Thanks! I tried that link and it says I'm not authorized to read that forum. How do I get in?


Re: Full Face not being replaced

Posted: Thu Mar 12, 2020 5:24 pm
by bryanlyon

Link was broken, I've fixed it, try again.