Manual Tool Reads Originals as Faces

The Extraction process failing on you, and you aren't getting an error back with clear instructions? Tell us about it here


Forum rules

Read the FAQs and search the forum before posting a new topic.

This forum is for reporting errors with the Extraction process. If you want to get tips, or better understand the Extract process, then you should look in the Extract Discussion forum.

Please mark any answers that fixed your problems so others can find the solutions.

Post Reply
User avatar
MaxHunter
Posts: 47
Joined: Thu May 26, 2022 6:02 am
Has thanked: 42 times
Been thanked: 6 times

Manual Tool Reads Originals as Faces

Post by MaxHunter »

I keep getting an error on the manual tool that it contains extracted face...but they're all original pics 🤷 None of them are PNGs either (for some reason this screws up the manual tool as well.) Thoughts? Is there a way to identify the problem picture?


User avatar
torzdf
Posts: 1979
Joined: Fri Jul 12, 2019 12:53 am
Answers: 139
Has thanked: 90 times
Been thanked: 433 times

Re: Manual Tool Reads Originals as Faces

Post by torzdf »

I'm not sure how to identify the actual image. However, the manual tool detects extracted faces (iirc) by reading the PNG header. If the PNG header doesn't contain faceswap information, it will load, if it does, then it will fail.

It doesn't check all the images (would take too long), I think it just checks the first image it finds.

Try again, make sure you are correct, because otherwise I'm going to have to go digging in the code to find out where the error gets raised. As this is the first report of this problem, I'm afraid that my suspicion is 'user error'

My word is final


Post Reply