I wanted to swap trainings on two machines that run on the same A/B dataset but with a different model setup.
So I just swapped the model folder and project file and everything looks to work fine.
But when I check model settings I get the settings from the previouse model.
Is this expected behaviour?
How am I able to change settings?
Model settings not updated after training swap
Read the FAQs and search the forum before posting a new topic.
This forum is for reporting errors with the Training process. If you want to get tips, or better understand the Training process, then you should look in the Training Discussion forum.
Please mark any answers that fixed your problems so others can find the solutions.
- Scrapemist
- Posts: 16
- Joined: Sat Nov 05, 2022 2:26 pm
- Has thanked: 8 times
Model settings not updated after training swap
Re: Model settings not updated after training swap
How are you checking model settings?
The specific model settings that are used for any model can be found in the state.json
file located in the model folder.
My word is final
- Scrapemist
- Posts: 16
- Joined: Sat Nov 05, 2022 2:26 pm
- Has thanked: 8 times
Re: Model settings not updated after training swap
Yes, I checked the state.json file.
But they are not the same as in the Training settings in the GUI.
I guess I should have saved them as a preset upon creation.
Re: Model settings not updated after training swap
You don't need to save them as a preset. What is shown in the GUI is what is currently stored in the relevant ,ini
files stored in faceswap's config
folder.
Most settings are locked to a model though, so once the model has been created, these settings won't change in the state.json
and will only take effect when starting a new model.
Settings which can be changed for existing models are labelled as such in the tooltips.
My word is final