The place to discuss Faceswap and Deepfakes
https://forum.faceswap.dev/
I wanted to swap trainings on two machines that run on the same A/B dataset but with a different model setup.
So I just swapped the model folder and project file and everything looks to work fine.
But when I check model settings I get the settings from the previouse model.
Is this expected behaviour?
How am I able to change settings?
How are you checking model settings?
The specific model settings that are used for any model can be found in the state.json file located in the model folder.
Yes, I checked the state.json file.
But they are not the same as in the Training settings in the GUI.
I guess I should have saved them as a preset upon creation.
You don't need to save them as a preset. What is shown in the GUI is what is currently stored in the relevant ,ini files stored in faceswap's config folder.
Most settings are locked to a model though, so once the model has been created, these settings won't change in the state.json and will only take effect when starting a new model.
Settings which can be changed for existing models are labelled as such in the tooltips.