Page 1 of 1
Squish bars for vertical and horizontal suggestion
Posted: Tue May 09, 2023 4:37 pm
by unkempt
First, I don't know if I never noticed before or it was a recent addition, but having the keyboard shortcuts for advancing slides and copying faces has been a HUGE performance booster!
Speaking of performance, I noticed that there are a series of off-angle faces that are hard to capture and I end up doing a face copy from the last good frame moving forward which is ok, but not great. Especially when the face is turning away or looking down in the next frames. I can fudge it a bit with the copied faces, but what would be a HUGE help is if I could squish the face vertically or horizontally (basically resize in one direction not both).
Re: Squish bars for vertical and horizontal suggestion
Posted: Wed May 10, 2023 4:35 pm
by torzdf
unkempt wrote: ↑Tue May 09, 2023 4:37 pm
First, I don't know if I never noticed before or it was a recent addition, but having the keyboard shortcuts for advancing slides and copying faces has been a HUGE performance booster!
Keyboard shortcuts have always been there 
unkempt wrote: ↑Tue May 09, 2023 4:37 pm
Speaking of performance, I noticed that there are a series of off-angle faces that are hard to capture and I end up doing a face copy from the last good frame moving forward which is ok, but not great. Especially when the face is turning away or looking down in the next frames. I can fudge it a bit with the copied faces, but what would be a HUGE help is if I could squish the face vertically or horizontally (basically resize in one direction not both).
Not sure what you mean here... If you mean the green "extract box" then, sadly, that would not be possible. This box represents the 'aligned extracted face' so has to be square.